In the process of using the pp pipe, if you are not careful, it will be flattened, and then the pipe will not be used normally. Therefore, in order to ensure the use of the pipe, how should we deal with the compressed pipe and how to eliminate this phenomenon.
Under normal circumstances, after the pp tube is produced, it is very regular. In many cases, in order to save space, large-diameter pipes will be placed on the bottom layer, and then stacked layer by layer. At this time, if the height is not more than 2.5 meters, there will be no damage to the pipes and will not be flattened. However, if a small-diameter pipe is set inside a large-diameter pipe, layer by layer, the bottom pipe will be greatly compressed, and then the pipe will be deformed and flattened. Of course, this is not the quality of the pipeline, but the use of wrong storage and transportation methods. Therefore, the flattening of the pipeline is mostly in the process of storage and transportation.
Generally, after the pp tube is flattened, we need to evaluate it to see whether the deformation is serious and whether it affects the use. If the tube can be used without problems, then we can use a circular corrector for treatment, which is more convenient and accurate. If there is no corrector at times, it can only be beaten on the tube to restore it to its original state. Here to remind us that this method is not advisable and can be used in emergency situations.
When we encounter the flattened pp tube, we should first check the degree of compression. If it is slightly flattened, it can be corrected first. If it is serious, it needs to be treated with a rectifier and restored to its original state. In fact, this phenomenon can be prevented with a little attention. Do not accumulate too high or too much during the storage and transportation process, and store and transport it reasonably and scientifically.
